The principal responsibilities essentially include :

- Design of HV & EHV AIS and GIS Substations.

- Knowledge in Engineering Specification and Standards (IEC, IEEE, ANSI, SEC, IS etc.)

- Ability to perform system studies like short circuit, load flow-P&Q in ETAP Software.

- Shall be able to review Grid impact study reports.

- Preparation of SLD (Single Line Diagrams) & the layout design for the GIS using 3D CAD tools.

- Preparation of Switchyard GA drawings, erection key drawing, clearance diagrams, and detailed technical specifications for all switchyard equipment s for the AIS and GIS up to 420 kV.

- Substation Earthing Calculation as per IEEE 80, IS 3043 and related standards: Earthing conductor sizing and earth mat design.

- Transmission line conductor sizing and Short circuit force calculation.

- Power Cable (HV and LV) sizing & calculation; Control Cable sizing, length Calculations and cable accessories selections.

- General Technical Parameters, Design Memorandum, check list preparation, Equipment sizing and configuration for the AIS and GIS.

- Lightning risk assessment and lightning calculations for design for the GIS substation as per IEC and IEEE guidelines.

- Sizing calculations for Lightning arrester, disconnector, power transformers, battery charger, CT - VT sizing with knee point voltage calculations and all associated equipment s for switchyard.

- Shall be able to design protection schemes as per various transmission voltage requirement. Relay setting calculations for unit and back up protections and shall be well know about distance relay settings.

- Able to understand and prepare Control Panel & Relay panel schematics, BOQ and Site accessories. Ability to select the components like (MCB, Contactor, Relays, connectors, etc.).

- Able to do pre-dispatch inspection and perform pre-commissioning test for all switchyard and solar plant equipment s independently. Coordination and support for testing and commission of Control & relay panel.

- Preparation of Mimic diagram with dimension and Alarm signals.

- Load calculation AC & DC

- Selection of BCU, Metering, Partial discharge (PD), Control Switch device (RPH) I/O cards etc.

Salary : upto 18 LPA

This job opening was posted long time back. It may not be active. Nor was it removed by the recruiter. Please use your discretion.