- Load demand calculation with load factor & diversity factor

- Voltage drop calculation

- System harmonics calculation

- Transformer & DG sizing for substation

- Power factor calculation & correction

- Bus Bar sizing

- IP rating

- Panel heat load calculation

- Arc flash calculation

- Earthing System calculation & design (Earth Pits, Earth Grids etc. )

- Cable tray & conduit sizing

- Power/control cabinets & Busbar system design

- Instrumentation:CT,PT,ameter,voltmeter,MFM etc.

- Switch Gear selection-(Protection: Fault current,overload,earth leakage)

- Starter selection- DOL/Star-delta/VFD etc.

- Selection of PLC (Siemens )

- Selection of panel cooling system

- Cable connection & distribution

- Cable specification selection (Types of cable)

- Sub-station design

- Transformer & DG selection

- APFC cabinets design

- Cable trays & conducting with support system

- SCADA integration

- BOQ, BOM

- Design Basis / brief report

- Equipment specification - PCC, MCC, HV Board, APFC, Motor, Genset, Transformer, Earthing, Lightning protection, Lighting fixtures, DB, Junction Box, Cable tray and Conduits, Cables

- Engineering information (Site execution) manual

- Single Line Diagram(SLD) preparation of complete power distribution network.

- Protection, Control and interlock diagrams.

- Schematic in E-Plan (PLC control & MCC cabinets)

- Cabinet detailed GA (PLC control & MCC cabinets)

- Layouts preparation (Panel, Substation, Cable tray,Lighting,earthing)

- Instrumentation and SCADA schematics

- Schematics - DG synchronisation, Load sharing and load shedding.

- Fault find-oveload,short circuit, earth leakage, tripping

- Onsite power analysis

- Installation support

- Help in electrical system commissioing onsite

- System study and improvements

- Internal arc testing

- Electrical equipment selection for hazardous area

- High efficiencies equipment like IE3

- Power analyzer

- Protection relay & their setting (Power system)