Electronics Hardware Engineer

- We are looking for Electronics Hardware Engineers in the team. In this role, it is expected that the candidate should have hands-on experience in electronics hardware design and development of digital analogue and mixed domain functional and performance circuits solutions. As a core member of EE team you will create design with microprocessors/ microcontrollers and peripheral interface such as memory devices, GPIO, power supply electronics and embedded systems bring-up.

Responsibilities :

1. Designing and development of new hardware functional system for multiple products.

2. Collaborate with with the embedded software development team for hardware/ firmware co-design and system performance requirement translating to design implementation ; optimization.

3. Ability to synthesize user and technical performance hardware requirements and develop appropriate solutions.

4. Electronic component and circuit analysis to design functional sub-system by simulation and physical implementation.

Requirements & Skills :

Must to have :

1. 2 years to 5 years of experience in low-power circuit design, system bring-up, engineering-build integration and debug.

2. 2 years to 4+ years of experience driving design development from component selection, schematic capture, PCB layout and routing, Component foot-print for the product Electronics BoM through assembly.

3. 3+ of experience in Multi-layer, mixed-signal board-level design in Altium/ Eagle.

4. Experience of power topology: DC-DC, Flyback Converters, LDOs, etc.

5. Experience of Battery charger design, fuel gauge, analogue sensor instrumentation; protection circuits.

6. Hand-on experience in hardware implementation of embedded system data communication protocols such as 1-wire, I2C, SPI, UART, USB.

7. Experience of BDC/BLDC or steppers motors, motor drive circuit design and its working principles.

8. Diverse experience in microcontroller/ microprocessor based circuit design and bring-up.

- Ideally from ST/ TI/ NXP/ Renesas and sensor interface on PCB assembly level.

9. Ability to design and implement smart sensors, sensors instrumentation like current, voltage signal conditioning, Time-of-Flight, Proximity, Position, ALS, etc on a PCB assembly level.

10. Knowledge about Design calculations/Documentation during Product Development Life Cycle milestones.

11.Knowledge of EMI- EMC and ESD standards and practices is a plus

Good to have :

1. Strong communication and documentation skills and ability to operate independently.

2. Experience with portable, battery operated designs and power budgeting.

3. Knowledge about Wi-fi, Bluetooth, BLE, RF Antenna design Technologies is a plus.

4. Experience of Microphone and Speaker circuit design is a plus

5. Familiar with PCB fabrication technologies, Rigid-Flex PCBs, Flex Cables.

6. Hand-on experience of manufacturing process including DFM and DFT for consumer products at scale.

7. Familiar with MIPI Camera CSI and DSI interface implementation ; display Modules and their communication protocols; Audio signal processing interface.

This job opening was posted long time back. It may not be active. Nor was it removed by the recruiter. Please use your discretion.