Job Responsibilities:

In all the areas of expertise listed above, the range of responsibilities of Process engineer in are:

- To elaborate and propose a complete set-up for Extended Well Test (EWT) facilities/Temporary production facility, Production Facilities (EPF) or Production facilities (PF), (sequence of several SLB or third-party assets), in order to treat the well head effluent received from well head with definite characteristics (composition, pressure, temperature, water content, etc..). The final objectives can be to meet export specifications or client specifications.

- To design new equipment in order to treat well effluent and any of well effluent phases in order to meet required specifications.

- To assess existing SLB or third-party assets to:

- Define their operating envelop.

- Define solutions required for debottlenecking or upgrading.

- Verify safety (pressure relief valves, relief lines, setting of alarms and switches)

- Safety concerns: verification and design of relief systems, including.

SLB-

- Private equipment pressure relief devices (pressures relief valves, ruptures disks, etc.- )

- Blowdown / depressurization systems

- Flares network (relief lines and headers) and flaring systems

- Environmental concerns:

- Design of process systems for treating effluents before disposal

- Heat radiation studies around flares.

- Gas dispersion studies in case of gas flaring and/or relief

The SWT Process Engineer is an effective support to all SLB locations all over the word, in order to provide solutions to meets production and safety requirements.

Process Engineer will also endorse Project Engineer role, so with the responsibility to manage a complete project (Concept study, FEED, Feasibility study, detailed engineering, etc..).

- Technical expert:

- Support to SLB locations on various technical matters.

- Realization and revision of design standards

- Trainings on matters related to Process Engineering

Skills Required:

Technical skills:

- Process engineering.

- Deep knowledge process equipment design (separators, tanks, pumps, heat exchangers,solids management, etc..). The principle in physics, thermodynamics, fluids mechanics considered for equipment design shall be understood.

- Conversant with Process datasheets for separators, tanks, pumps, heat exchangers.

- Flowsheets and block flow diagrams

- Definition of Basis of design

- Process Flow Diagrams (PFD), Process and Instrumentation Diagrams (P&ID)

- Cause and Effect diagrams.

- Definition of requirements and specification for instruments (control valves, flowmeters, etc..)

- Line sizing.

- Calculations notes and reports.

- Extensive knowledge and practice of process simulation software (hysys suite, Pro II, Aspenflare system Analyzer, Aspen EDR, HTRI, Symmetry, Flaresim, etc..)

- Understanding of project phasing (feasibility, Detailed engineering) and impact of workflow,stakeholders and deliverables

- General knowledge of petroleum products main physical and chemical characteristics driving process design

- Safety in design:

- Definition of requirements and specification of pressure relief devices (pressure relief valves, rupture disks, HIPPS, etc.)

- Design a relief network in accordance with recognized industrial practices.

- Extensive knowledge of API standards (520, 521, 2000, etc..) is absolutely required.

- Safety reviews (HAZOP, HAZID, LOPA, etc.)

- Knowledge in Gas dispersion studies is an advantage.

- Industrial codes:

- Deep knowledge and practice of API standards, in particular API 520, 521, 537, 2000, 12J,14C, 14E